Fasteners

Uniform diameter the entire length of the shaft with a flat end.

Screws that create their own thread but typically requires a pilot hole. Also known as sheet metal screws.

Screws that drill, tap, and fasten in a single operation. Also known as TEK screws.

Very strong fasteners that are generally used to connect heavy materials such as lumber. Also known as lag bolts.

Screws that are hammered into the material like nails but offers the holding power of fasteners. Also known as Type U drive screws or hammer screws.

Headless fasteners with a lag thread at both ends. Also known as hanger bolts.

Screws used to join thin metal together or metal to other materials.

Bolts with hexagonal heads used in construction and machine assemblies.

Bolts with square or ribbed neck that prevents the bolt from turning when the nut is installed or removed.

Bolts that meet specific ASTM standards that are rated for high load applications to make structural connections.

Bolts with washer like flange underneath the head of the screw. Also known as washer bolts.

Bolt that is threaded on both ends to add an external thread to a wooden surface.

Bolt that can be used with hex nuts or tapped holes.

Heavy duty bolts that sit flush with the surface and has a square neck to prevent turning when installing the nut.

Square head design that makes it easy for the operator to grip the bolt when installing the nut.

Bolts with thin and flat head to sit flush against the surface to prevent obstructions within confined spaces.

Bolts with an oversized head and fins underneath the head. Commonly used in wood and marine applications.

Bolts with wide round head and square neck. Commonly used as climbing steps in utitlity poles and towers.

Screws with higher torque and holding power.

Threaded tubes to connect, separate, or position parts in assembles.

Unthreaded hollow tubes that connect components while maintaining a fixed distance between them.

Sealing washers create a tight seal around fasteners to prevent fluids and gases from leaking.

Commonly known as Pop rivets. Allow objects to be fastened together when only one side can be accessed or seen.

Suited for general purpose use.

Suited for low voltage cables, wires, and cords.

Suited for inuslated cables, wires, and cords.